Turning Projector On

Introduction

This guide details how to turn on the projector in Mackey Hall. Below, see detailed instructions.

If you need information on turning off the projector, please refer to this article.

Note Regarding Wall Controls

Please note that since the replacement of the projector a few years ago, the controls on the wall outside of the choir closet only operate the video switcher. The projector's power cannot be controlled using these wall controls. Instead, you will need to use the projector remote to turn the projector on or off.

Projector Remote

The projector remote is typically located in the second drawer from the bottom on the sound system rack. If it is not there, please check the computer desk outside the choir closet. There is a possibility that the remote is sitting on the desk underneath the protective cloth.

Power On Projector

To power on the projector, follow these steps:

1. Position yourself somewhere near the projector.
2. Point the remote somewhere near the projector.
3. Press the remote's "On" button to power on the projector (see image below). This action will initiate the power-on sequence.
4. Confirm that the red light on the underside of the projector starts flashing blue, indicating that it is powered on.
5. Please allow approximately 30 seconds for the projector to fully power on. During this time, be patient and avoid any further interaction with the projector.
6. Once you have finished, please remember to return the remote to its original location.